Carbon Water Filters for Colour, Taste and Smell

Tank, bore and town water.
Book a FREE onsite visit.

What does a carbon water filter do?

A carbon water filter runs your water through a bed of activated carbon: carbon that has been treated so it’s full of tiny pores. The chemicals that give water a colour, a taste or a smell stick to the carbon as the water passes through. The government’s guide for homes on their own supply, Household Water Supplies, lists activated carbon for colour, for taste and odour, and for pesticides.

It’s the filter we reach for when:

  • Tank water comes off an asphalt shingle or bitumen roof: yellow, brown or green-tinged water with a smell or a chemical taste. See asphalt and bitumen roofs.
  • The water is tea-coloured: tannins from leaves, bush and peat. See tannins.
  • Town water tastes or smells of chlorine.

A carbon filter doesn’t kill germs, and it isn’t the fix for iron, hard water, or lead and copper. On tank, bore or stream water it goes before a UV system, never instead of one.

We fit and service carbon filters across Rodney and North Auckland, from Mangawhai to Albany.

Start with a free onsite visit.

Backwashing carbon filter beside cartridge filters and a UV system in a shed at Coatesville

Why a big backwashing carbon filter?

Carbon only works until it’s full.

Carbon fills up

Household Water Supplies says activated carbon “will eventually become full of contaminants and must be replaced to prevent contaminants returning to the water.” A small carbon cartridge fills up fast on badly coloured tank water. That’s fine for a chlorine taste in town water, but not for an asphalt roof.

A big tank lasts the year

For whole house colour, taste and smell we fit a tall tank of granular activated carbon, 12 x 52 inches on most homes. It holds far more carbon than a cartridge, and the water spends longer in contact with it.

It cleans itself

On a timer, the control valve runs water backwards through the carbon and out to a drain. That rinses out trapped grit and loosens the carbon so it doesn’t clog, then the filter rinses and goes back into service.

The UV goes after it

The same guide says carbon granules “can act as a growth medium for bacteria”, so the UV always comes after the carbon. Taking out the colour helps the UV too: colour and dissolved organic matter shield germs from UV light.

Signs you need a carbon filter

Yellow, brown or green-tinged water.

Colour that shows most in a full bath.

A musty, earthy or chemical smell.

A metallic or chemical taste.

An asphalt shingle or bitumen roof.

Black grit or beads of bitumen in the gutters or tank.

Tea-coloured water from tannins.

A chlorine taste or smell in town water.

Water that still tastes off with new sediment filters.

Bath filling with yellow-green tank water from an asphalt shingle roof at Coatesville

Coatesville, 2024. Green-tinged water, worst in the bath, with a slight smell. The home has an asphalt shingle roof.

New home in Coatesville with a grey asphalt shingle roof

The roof it came off. We’ve seen the same yellow, brown or green water under asphalt shingle roofs from Omaha and Point Wells to Dairy Flat.

What a carbon filter does

  • Reduces colour, taste and smell.
  • Reduces the chlorine taste and smell in town water.
  • Reduces pesticides, says Household Water Supplies.
  • Treats the water for every tap in the house.

What it doesn’t do

  • Kill bugs. You still need a UV system after it.
  • Take out iron, manganese or hardness.
  • Fix lead or copper from the roof or pipes. That needs a different fix: see roof materials.
  • Clean your tank. If there’s sludge or bitumen grit in it, clean the tank first.

Clean-tasting water, then safe water.

Local Jobs. Local Trust. Local Experts.

Recent carbon filter jobs

A few of the colour, taste and smell problems we’ve sorted.

Blue backwashing carbon filter tank with a spin-down filter in a garden shed at Coatesville

Coatesville: the fix for the green-tinged bath water. A backwashing carbon filter, with a spin-down filter ahead of it, then the cartridges and UV.

Backwashing carbon filter installed beside the pump and sediment filter at a home in Point Wells

Point Wells: a backwashing carbon filter beside the pump and sediment filter, for a home with an asphalt shingle roof.

Backwashing carbon filter tank with a spin-down filter in a garage at Dairy Flat

Dairy Flat: a backwashing carbon filter and spin-down filter in the garage. Pre-tank filters on the tanks catch the roof grit first.

How we fit a carbon filter

For most homes we fit a 12 x 52 inch backwashing tank of granular activated carbon with an automatic control valve. On a tank system it usually goes after the pump and a spin-down filter, and ahead of the cartridge filters and the UV, so the UV is the last thing the water passes through.

It needs a firm, level base with a seismic restraint, a power point for the control valve, and a drain for the backwash water. Your pump has to deliver enough flow to backwash the carbon properly. We check all of this at the free onsite visit, and tell you if anything needs changing first.

On town water where the only problem is a chlorine taste, a carbon cartridge in a standard filter housing is often enough. We’ll tell you which suits your water.

Carbon cartridge or backwashing carbon filter?

Both use activated carbon. The difference is how much carbon there is, and whether it cleans itself.

Carbon cartridges

A carbon block or granular carbon cartridge in a standard filter housing. They suit town water, where the job is mostly a chlorine taste and smell, and under-bench drinking water filters. They cost the least to start with, but they fill up, and on badly coloured tank water they don’t last long.

Backwashing carbon filters

A tall tank of granular activated carbon with a control valve on top. It holds far more carbon, cleans itself on a timer, and treats the water for the whole house. It’s what we fit for asphalt and bitumen roofs and strong colour. It needs a drain, power and a firm base, and it uses some water each time it backwashes, which matters on tank water. We sell the Ecosoft FPA 1252 supply only in our shop: see the Ecosoft FPA 1252 backwashing carbon filter.

When carbon isn’t the answer

Not all coloured water is a carbon job. Strong tannins in bore or stream water may need a tannin resin filter instead, orange or black water is usually iron or manganese, and lead or copper need a different fix again. Which you need depends on a water test, how much water you use and what’s causing the problem.

Ecosoft FPA 1252 backwashing carbon filter with a black tank and control valve

Featured Product

Ecosoft FPA 1252 Backwashing Carbon Filter

The whole house backwashing carbon filter we fit most often for colour, taste and smell, including tank water from asphalt shingle and bitumen roofs. 25 kg of activated carbon in a 12 x 52 inch tank. Supply only, for pick up from our Warkworth shop. Not sure if it’s the right fit? Call us and we’ll come out for a free onsite visit.

$2,600.00 excl. GST

Fix the source first

A carbon filter does its best work when less comes off the roof in the first place.

Clean the tank. If there’s black sludge or bitumen grit on the floor, have the tank cleaned first, or the carbon will be fighting it all year. We use Cross Country Tank Cleaning and Mobi Kair.

Keep the grit out. Gutter guards, a first flush diverter and pre-tank filters catch bitumen grit before it reaches the tank: see rainwater harvesting. Asphalt shingle roofs shed more grit as they age, so keep the gutters and filters clean.

Choosing a roof? On a new build or a re-roof, pick a roof that suits drinking water: see dangerous roof materials.

Test your water

A lab test tells us what’s causing the colour, taste or smell, whether carbon is the right fix, and whether anything else needs treating, such as E. coli, iron or acidic water.

For roof problems we use Hill Laboratories, which can test for the metals and the hydrocarbons (PAHs) that can come off a roof. See water testing.

How we fix coloured or smelly water

Every job follows the same four steps.

1

Free onsite visit

We look at your roof, gutters, tanks, pump, filters and UV.

2

Test the water

We check the water on site and send a sample to the lab if needed.

3

Install

Our registered plumbers fit the carbon filter and backwash drain to suit your water and how much you use.

4

Service

We replace the carbon and service your UV each year, and remind you when it’s due.

Carbon filters and the rest of your system

Tap a card to find out more.

Professional installation

Our own registered plumbers install backwashing carbon filters across Rodney and North Auckland, from Mangawhai to Albany. We’ve fitted them in Coatesville, Omaha, Dairy Flat, Matakana, Kumeu, Warkworth, Redvale and Point Wells.

  • Matched to your water and a water test.
  • Sized for your house and how much water you use.
  • Fitted on a firm base with a seismic restraint and a proper backwash drain.
  • Set up in the right order: sediment filter, carbon, then UV.

Ongoing service and support

Carbon gets used up, so we service carbon filters every 12 months: we replace the carbon and service your UV and cartridges at the same visit, and we remind you when it’s due. See water filter and softener servicing.

Moved into a house with a tall filter tank and no idea what’s in it? We service those too, even if we didn’t install them.

Carbon filter FAQs

What is a carbon water filter?

A filter filled with activated carbon: carbon that has been treated so it’s full of tiny pores. Chemicals that cause colour, taste and smell stick to the carbon as the water passes through. It comes as a cartridge, or as a tall tank of granular carbon that backwashes itself.

What does a carbon filter remove?

Colour, taste and smell, the chlorine taste in town water, and pesticides. Household Water Supplies lists activated carbon for all of these. It doesn’t kill bacteria, and it doesn’t take out iron, manganese, hardness or nitrate.

Will a carbon filter fix water from an asphalt roof?

It’s what we fit for asphalt shingle and bitumen roofs. A large backwashing carbon filter reduces the yellow or brown colour, the smell and the taste, and Health Canada rates granular activated carbon as the best available treatment for benzo(a)pyrene. Keep the grit out of the tank too, and put the UV after the carbon.

Does a carbon filter kill bacteria?

No. Household Water Supplies says carbon granules “can act as a growth medium for bacteria”. On tank, bore or stream water, a UV system goes after the carbon to kill the germs.

Do I need a sediment filter before a carbon filter?

Yes. Grit and dirt clog the carbon and shorten its life, so a spin-down or screen filter goes before it. Cartridge filters and the UV go after it.

How often does the carbon need replacing?

We replace it about once a year, at the yearly service. Household Water Supplies says carbon “will eventually become full of contaminants and must be replaced”. How fast depends on how much is in your water and how much you use.

How does a backwashing carbon filter work?

In normal use the water flows down through the carbon. On a timer, the control valve reverses the flow, lifting and rinsing the carbon and sending the dirty water to a drain. Then it rinses and goes back into service.

Does a backwashing filter waste water?

It uses some water each time it backwashes, which matters on tank water. The Ecosoft FPA 1252 uses 400 to 800 litres per backwash, its data sheet says. The valve can backwash anywhere from every day to every 99 days, so we set it to suit your water and how much you use. The backwash needs a drain or somewhere to soak away.

Carbon cartridge or backwashing carbon filter?

Cartridges suit a chlorine taste in town water and under-bench drinking water filters. Strong colour, roof problems and whole house treatment need a backwashing carbon filter, which holds far more carbon and cleans itself.

What does a backwashing carbon filter need?

A firm, level base with a seismic restraint, a power point for the control valve, a drain for the backwash water, and a dry, sheltered spot such as a shed or garage. Your pump also needs enough flow to backwash it. We check all of this at the free onsite visit.

Can I buy a carbon filter from you?

Yes. The Ecosoft FPA 1252 backwashing carbon filter is in our shop, supply only, for pick up from 2 Mill Lane, Warkworth. It needs a drain, power and a proper base, so most customers have us install it after a free onsite visit.

Do you service carbon filters?

Yes. We service backwashing carbon filters every 12 months. We replace the carbon, soak it and recommission the filter, check the control valve and its backwash settings, and service your UV and cartridges at the same visit. Ecosoft’s manual advises servicing these filters at least once a year, or twice a year if the water has a lot of iron.

Will you remind me when my filter needs a service?

Yes. Once we’ve serviced or installed your system, we keep its details on file and get in touch when the next 12-monthly service is due, so you don’t have to remember.

I’ve moved into a house with a filter tank. What is it?

Tall fibreglass filter tanks like the ones on this page usually don’t say what’s inside. It could be carbon, a neutraliser for acidic water, softener resin, or media for iron or sediment. We can service any of them, even if we didn’t install it. We work out what’s in the tank from the control valve, any labels and a water test, then fit the right media and set the valve up for your water.

Don’t just take our word for it…

Read our Google reviews

⭐⭐⭐⭐⭐

“We have an advanced rain water treatment system at our Mangawhai Heads home which includes whole house neutralisation, UV treatment and 3-stage filtration with KDF/GAC, primarily for removal of copper contamination from gutters and down pipes. The system was supplied and installed by Aqua Works and has just had its first annual service by them. We have been totally satisfied with the expert service throughout …”

Richard Mules, 2025

⭐⭐⭐⭐⭐

“Excellent on-going service. Would highly recommend these guys to fix any water issues. Loving the taste of my water. 2025: Another great service conducted – technician arrived on time, friendly and very efficient. Continue to highly recommend these guys and the whole of house filtration system to everyone.”

Tony Cohen, 2025

⭐⭐⭐⭐⭐

“… I have a water filtration system installed every year in the kitchen on my cold tap, and the water tastes fantastic. The water comes out of the tap normally (no long wait times) and there are no chlorine or gross metal tastes. I highly recommend the filter system and the AquaWorks team for all your water requirements.”

Mary Anne Church, 2026

Coloured or smelly water?

Book a FREE onsite visit. We’ll find the cause and fit the right filter.